Read or Download 360 SYSTEMS DigiCart II+ Digital Audio Hard Disk Recorder (DR-2750) PDF
Best nonfiction_6 books
- Grammars of Creation [INCOMPLETE]
- Evaluation of Patients with Congenital Adrenal Hyperplasia
- Almgren's big regularity paper : Q-valued functions minimizing Dirichlet's integral and the regularity of area-minimizing rectifiable currents up to codimension 2
- M-20.2 Emergency Escape Breathing Device (operators, maintenance)
- Browning 35 All-Wave Receiver
- Minority Language Media: Concepts, Critiques and Case Studies (Multilingual Matters)
Extra info for 360 SYSTEMS DigiCart II+ Digital Audio Hard Disk Recorder (DR-2750)
SYNC SOURCE INTERNAL OR SYNC SOURCE DIGITAL INPUT Digital Output The DigiCart/II Plus can output audio on all output connectors simultaneously. Analog output is always available on the analog connectors. However, the DIGITAL OUTPUT can be disabled or enabled and can output data in one of three selected formats. The DIGITAL OUTPUT menu enables or disables the digital outputs and selects the format of the digital audio at the outputs. By default, recordings made from the analog inputs and the professional AES/EBU or AES/SMPTE-75 inputs are not copyright protected when output in the consumer format.
To activate looping, press the LOOP button while the cut is playing. The LOOP button will illuminate. Once looping is on, that cut will play continuously until looping is turned off by one of the methods listed below. Looping can be used with Playlists. Looping can be turned on and off at any time without affecting the Playlist. While one cut is looping, you may use the SELECT control and press the PLAY button to add additional cuts to the Playlist. When you turn off looping, DigiCart/II Plus will proceed with playback of the remaining cuts in the Playlist.
Loop may also be turned off by pressing the STOP button once. Pressing the STOP button twice during Loop mode will immediately stop playback of the current cut, and all other cuts in the playlist. DigiCart/II Plus Owner's Manual Operating Instructions • 27 Cues A cue pointer is used to control a relay circuit present on the rear panel CUE OUTPUTS connector on a DigiCart/II Plus. The relay provides "Form C" contacts allowing you to connect or disconnect a circuit. You may also redirect a signal from one destination to another, or select between two available signals when the cue occurs.
360 SYSTEMS DigiCart II+ Digital Audio Hard Disk Recorder (DR-2750)